#Saturation before or after compression professional

It has a mastering algorithm that is perfect for subtly compressing and amplifying different parts of the sound spectrum, such as midrange frequencies (which are typically located in vocals or guitars). You can use the FabFilter Pro-C2 compressor to master your tracks. With oversampling enabled later on as well (which reduces peaking), you are left with an even better sound than before! I also ensured transients were retained through these changes, which made for a more impressive kick, vocal, and high-hats. I also took my time to experiment with the attack and release of each band in order to make sure that distortion was eliminated. Although any change made could make other aspects worse while bringing out new parts (like changing dynamics), what matters most about mastering music is making sure nothing stands out negatively overall! When doing mastering like this, itвЂ™s important that there are no loud areas because they may cause distortion if pushed too far before reaching 0dB once again.

You need a range of frequencies from low and high, so you should set up some bands with this compressor by enabling it on each section separately for instance, вЂњbassвЂќ or вЂњhighs.вЂќ This is done when setting parameters such as amplitude and how responsive the signal will be in relation to changes. You can use multiband compression to master your audio track using the FabFilter MB Multiband Compressor. Soft feet can be better for controlling peaks though if you want something smoother sounding than an extreme attack time which would sound like вЂњpuh!вЂќ One other important distinction is that hard knees are more accurate in what theyвЂ™re doing because thereвЂ™s less variation depending on how high or low your input level was before hitting the compressor. Hard knee compressing happens when the signal gets loud enough, while soft-knees will compress at any volume as long as you have set it to do so with the threshold knob. The difference between hard and soft-knee compression is a point of contention among audio engineers. In general, hard knee tends to be optimal when compressing drums or bass instruments where the uncompressed level can vary at different points in time this way any change of volume is immediately compensated by high ratio values making sure your listeners donвЂ™t have trouble hearing these quieter parts compare to louder ones.

#Saturation before or after compression professional

Soft-knee will give you smoother tones with less transient sounds that make the track more dynamic and professional sounding. Hard-knee compression is most often used for mastering, as it gives a punchier sound.